A numerical analysis on taper tube hydroforging

No Thumbnail Available
Authors
Memon, Shabbir
Nikhare, Chetan P.
Advisors
Issue Date
2022-10-30
Type
Conference paper
Keywords
Bulging , Low Pressure , Numerical simulation , Taper tube , Tube hydroforging
Research Projects
Organizational Units
Journal Issue
Citation
Memon, S, & Nikhare, CP. "A Numerical Analysis on Taper Tube Hydroforging." Proceedings of the ASME 2022 International Mechanical Engineering Congress and Exposition. Volume 2A: Advanced Manufacturing. Columbus, Ohio, USA. October 30–November 3, 2022. V02AT02A054. ASME. https://doi.org/10.1115/IMECE2022-95536
Abstract

Typically, in tube forming, the end cross section is either expanded or reduced, or the tube is bent around a solid mandrel to achieve the desired shape. To reduce the friction generated between the tube and the physical tool like mandrel the tube hydroforming process was developed. The fluid was highly pressurized to expand the tube to a desired shape. The uniform thickness and thus better formability are achieved by replacing mandrel punch with hydraulic pressure in tube hydroforming. If the axial force to deform the tube is dominant in deforming the tube, then the process is termed as hydroforging. In this paper a two-step hydroforging process is discussed. With this two-step process, firstly the tube is bulged using the low fluid pressure and then axial force was applied to deform the tube axially and circumferentially while a constant internal fluid pressure was applied to prevent the buckling. During the first step a ramp pressure is used to provide a maximum bulging without necking, then in the next step a constant same peak ramp pressure or lower is applied while compressing the tube axially. In the previous study, a straight tube was used to study the pressure requirement, bulging, buckling and deformation mechanics to create a disc shape object. In this paper, a taper tube hydroforging was studied. The same two-step process was applied to bulge the tube first and then axially deform the tube. Two tube thicknesses and three angles were studied. The pressure requirement to bulge the tube and deform the tube was investigated. The deformation mechanics was analyzed. In addition, the stress, strain, and thickness distribution were studied and reported.

Table of Contents
Description
Click on the DOI to access this article (may not be free).
Publisher
ASME
Journal
Book Title
Series
ASME 2022 International Mechanical Engineering Congress and Exposition
Volume 2A: Advanced Manufacturing
PubMed ID
DOI
ISSN
EISSN