Show simple item record

dc.contributor.authorPaidar, Moslem
dc.contributor.authorBokov, Dmitry O.
dc.contributor.authorMehrez, S.
dc.contributor.authorOjo, Olatunji O.
dc.contributor.authorRamalingam, Vaira Vignesh
dc.contributor.authorMemon, Shabbir
dc.date.accessioned2021-10-27T15:23:39Z
dc.date.available2021-10-27T15:23:39Z
dc.date.issued2021-11-25
dc.identifier.citationPaidar, M., Bokov, D., Mehrez, S., Ojo, O. O., Ramalingam, V. V., & Memon, S. (2021). Improvement of mechanical and wear behavior by the development of a new tool for the friction stir processing of Mg/B4C composite. Surface and Coatings Technology, 426 doi:10.1016/j.surfcoat.2021.127797en_US
dc.identifier.issn0257-8972
dc.identifier.urihttps://soar.wichita.edu/handle/10057/22248
dc.identifier.urihttps://doi.org/10.1016/j.surfcoat.2021.127797
dc.descriptionClick on the DOI link to access the article (may not be free).en_US
dc.description.abstractLarge and irregular particle sizes of B4C in the Mg matrix are performance-impeding challenges of the as-cast Mg-B4C composites. In an attempt to overcome this, the secondary solid-state friction stir processing of the as-cast Mg-10%B4C composite with a flow-enhancing double-pin tool was carried out and the ensuing result was compared with that of a single-pin tool. The microstructure, hardness, tensile strength, wear, and the fractured surface of the processed composites were investigated and compared. The extra pin-shearing effect and the complex pin-induced interactive material flow of the double-pin tool induce better refinement of the B4C particles in the Mg-10%B4C composite. The use of a double-pin tool increases the stirred and recrystallized vortex/swirl width, kernel average misorientation (KAM) fraction, dislocation density, hardness value at the stirred center (117 HV), and tensile strength (194 MPa) of the Mg-10%B4C composite as compared to the single-pin tool. The double-pin tool changes the fracture path of the composite away from the stirred center owing to the improved material flow and properties of the stirred center. The tribological properties (weight loss, wear rate, and coefficient of friction) of the processed composites are equally improved by the double-pin tool. A double-pin tool is thus recommended for the improvement of material flow, particle-disintegration, mechanical and tribological properties of Mg-based metal matrix composite.en_US
dc.language.isoen_USen_US
dc.publisherElsevieren_US
dc.relation.ispartofseriesSurface and Coatings Technology;Vol. 426
dc.subjectFriction stir processingen_US
dc.subjectDouble-pin toolen_US
dc.subjectSingle-pin toolen_US
dc.subjectMg-B4C compositeen_US
dc.subjectWearen_US
dc.subjectMechanical propertiesen_US
dc.titleImprovement of mechanical and wear behavior by the development of a new tool for the friction stir processing of Mg/B4C compositeen_US
dc.typeArticleen_US
dc.rights.holder© 2021 Elsevier B.V. All rights reserved.en_US


Files in this item

FilesSizeFormatView

There are no files associated with this item.

This item appears in the following Collection(s)

Show simple item record