• Login
    View Item 
    •   Shocker Open Access Repository Home
    • Engineering
    • Industrial, Systems, and Manufacturing Engineering
    • ISME Faculty Scholarship
    • ISME Research Publications
    • View Item
    •   Shocker Open Access Repository Home
    • Engineering
    • Industrial, Systems, and Manufacturing Engineering
    • ISME Faculty Scholarship
    • ISME Research Publications
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Infrared measurement of the temperature at the tool-chip interface while machining Ti-6Al-4V

    Date
    2017-05
    Author
    Heigel, Jarred C.
    Whitenton, Eric
    Lane, Brandon
    Donmez, Mehmet A.
    Madhavan, Viswanathan
    Moscoso-Kingsley, Wilfredo
    Metadata
    Show full item record
    Citation
    Heigel, Jarred C.; Whitenton, Eric; Lane, Brandon; Donmez, Mehmet A.; Madhavan, Viswanathan; Moscoso-Kingsley, Wilfredo. 2017. Infrared measurement of the temperature at the tool-chip interface while machining Ti-6Al-4V. Journal of Materials Processing Technology, vol. 243:pp 123–130
    Abstract
    The challenges associated with machining titanium alloys (e.g.,Ti-6Al-4V) are directly related to high cutting tool temperatures due to the low thermal conductivity of these alloys and the heat generated in the primary shear zone and at the tool-chip interface. Transparent yittrium aluminum garnet (YAG) tools are used in the current study to orthogonally machine a Ti-6Al-4V disk. Although YAG tools are not industrially relevant, they permit the temperature on the tool-chip interface to be measured. These measurements are relevant because they can be used to validate cutting models, which are in-turn used by industry to improve cutting processes. An infrared camera, using a high frame rate (700 Hz) and a large field of view (20 mm(2)), observes the tool-chip interface through these tools and measures the temperature distribution and records the chip curl and breakage while cutting with a feed rate of 50 mu m/rev and cutting speeds between 20 m/min and 100 m/min. In addition to the temperature measureirlents, cutting forces are recorded and the chip formation is documented using a high-speed (3 kHz) visible-light camera. Results show that radiant temperature increases with speed while the cutting and thrust fortes show no significant trend. Analysis of the temperature distribution from one edge of the chip to the other reveals differences from 6 % to 21 %, indicating that caution must be used when performing thermographic measurements of chip temperatures from the side of the cutting zone. Finally, post process measurements are performed using a scanning white-light interferometer to investigate any correlation between the tool condition and cutting temperature. Although the qualitative analysis of some cases appears to reveal a correlation between the condition of the YAG tool and the measured temperature distribution, further work work is required to understand this relationship.
    Description
    Click on the DOI link to access the article (may not be free).
    URI
    http://dx.doi.org/10.1016/j.jmatprotec.2016.11.026
    http://hdl.handle.net/10057/12931
    Collections
    • ISME Research Publications

    Browse

    All of Shocker Open Access RepositoryCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsBy TypeThis CollectionBy Issue DateAuthorsTitlesSubjectsBy Type

    My Account

    LoginRegister

    Statistics

    Most Popular ItemsStatistics by CountryMost Popular Authors

    DSpace software copyright © 2002-2021  DuraSpace
    Contact Us | Send Feedback
    DSpace Express is a service operated by 
    Atmire NV